Mon Oct 25, 2010 9:15 pm Post
Mon Oct 25, 2010 10:54 pm Post
Now, as I've said, I might just be misunderstanding the words, but when I think of 'padlock' I think of a lock with a loop and when I see the picture that is used on the icon, I think of a 'key.'The padlock button on the far right allows you to “lock” the inspector to a particular editor when the editor is split - we won’t worry about that for now, though, as we haven’t looked at splitting the editor yet.
Mon Oct 25, 2010 11:34 pm Post
b) Now - well, after you’ve read this bit, so you know how to get back - click on the corkboard icon again, while viewing this document. You will see that the corkboard is blank. This is because this document (“Step 7: Changing Editor Views”) doesn’t have any subdocuments - but it could.
This is because this document (“Step 7: Changing Editor Views”) doesn’t have any subdocuments - but it could. After you’ve seen the blank corkboard, click on the text icon to the left of the corkboard icon in the toolbar icon to see the text of the document again:3. Outliner Mode
Outliner mode is much like the corkboard mode, allowing you to see the subdocuments of the current document, except that it shows them as rows
Tue Oct 26, 2010 12:32 am Post
Each index card will now display a pin holding it in place that is the colour of the label associated with the document.You can also select Show Stamps via View > Corkboard, which places a diagonal stamp on the cards
Tue Oct 26, 2010 12:45 am Post
Tue Oct 26, 2010 2:19 am Post
Tue Oct 26, 2010 2:36 am Post
Tue Oct 26, 2010 2:45 am Post
DukTape wrote:I think I killed my tutorial. I was just near the beginning, where it said to drag step 3 to the header view (and I don't know if that meant in the binder or up top, so I did it in the binder). Then I was reading it, and thought I'd put it back where it belonged, I mean with its level back at the same level as the other steps. Only somehow both steps 2 and 3 disappeared on me. I hit ctrl+z a few times, but it didn't bring it back. I closed the tutorial without asking it to save, but those steps are still nowhere to be seen.
Tue Oct 26, 2010 2:47 am Post
nohika wrote:Going under "Help, Tutorial" and opening that document. Click on Part 1: Step 3.
Under the yellow bar, the text "Now try changing the percentage in the popup-button at the bottom, too (click on it and select a new percentage)—you will see that you can make the text bigger or smaller; useful for tired eyes."
In total there are 4 users online :: 0 registered, 0 hidden and 4 guests (based on users active over the past 5 minutes)
Most users ever online was 1048 on Mon Feb 06, 2012 9:07 pm
Users browsing this forum: No registered users and 4 guests