Fri Jan 10, 2020 11:50 am Post
Fri Jan 10, 2020 3:11 pm Post
Fri Jan 10, 2020 4:35 pm Post
tiho_d wrote:We found a problem with the drawing caused by the new replacement functionality. If you have used find/replace please, close the project and open it again. No data is lost, but redrawing the text might not work. After re-opening the project and the document it should be fine. We will release a new update on next Monday with a fix, or switch back to Beta 32.
Sat Jan 11, 2020 5:14 am Post
keithyd wrote:I'd love to have gone back to Beta 32 (having just spent an hour reinstalling and updating 1.9, then copying over my recent work there ) but I couldn't find it anywhere on the L&L site. Do you have a link? Or a procedure to roll back?
Sat Jan 11, 2020 10:46 am Post
narrsd wrote:keithyd wrote:I'd love to have gone back to Beta 32 (having just spent an hour reinstalling and updating 1.9, then copying over my recent work there ) but I couldn't find it anywhere on the L&L site. Do you have a link? Or a procedure to roll back?
The installers for Beta 32 appear to be still present, via these links:
Presuming they'll stay until Monday, anyway -- good fortune.
Sat Jan 11, 2020 3:58 pm Post
tiho_d wrote:Re-opening the project without using the text replace functionality should not cause any issues. Can you please upload a small project with few documents and steps to reproduce the issue?
Sat Jan 11, 2020 5:34 pm Post
Sat Jan 11, 2020 10:14 pm Post
tiho_d wrote:Glad we sorted this re-draw glitch!
About the copy/paste image resulting in <!$Scr_Cs::0>. Can you please upload a project with one document and the image separator, with few steps that reproduce the problem. Most likely you have a character style set on the image, or around the image, which is causing the side effect upon copy/paste of the image. This will help us reproduce the problem.
Sun Jan 12, 2020 8:50 am Post
Sun Jan 12, 2020 12:24 pm Post
tiho_d wrote:Thanks Keith.
1) The issue after using find/replace we already sorted out and a fix is coming in the next update Beta 34.
2) About the trailing characters that you describe "<!$Scr_Cs::0><!$Scr_Cs::1>". As I mentioned earlier, if your image has a character style applied to it. Copy/paste of the image causes this bug. Your demo project is not showing the problem, but most likely your original project is. To fix this, select the image and remove any style you might have accidentally applied to it. To clean the <!$Scr_Cs::0> leftovers from the previous copy/pastes, either wait for the next build, or use project search and delete this text manually, without using search and replace.
In total there are 5 users online :: 1 registered, 0 hidden and 4 guests (based on users active over the past 5 minutes)
Most users ever online was 1048 on Mon Feb 06, 2012 9:07 pm
Users browsing this forum: steveshank and 4 guests