Fri Sep 06, 2019 9:17 am Post
Fri Sep 06, 2019 1:14 pm Post
Fri Sep 06, 2019 3:19 pm Post
Fri Sep 06, 2019 3:58 pm Post
Silverdragon wrote:I've done this for years with stacked corkboards. See Mac manual section 8.2.8.
Hope this helps!
EDIT: I see that you're a Windows user. In that case, stacked corkboards may not be available to you. I would expect them to be in the Beta, but what do I know? In any event, this feature works quite well for the purpose on Mac, and would be the thing to check if it exists on Windows, and to request if not.
Sun Sep 08, 2019 11:53 am Post
rdale wrote:Silverdragon wrote:
In the binder, select the Act folders, and then switch the editor to cork board mode. To change how the lanes are arranged, use the buttons in the lower right of the editor. The only downside is that you don't see the container in each of the rows, but you could put a placeholder document in each act folder as the first one, and un-check the "include in compile" checkbox in the general metadata pane of the inspector.
In total there are 8 users online :: 0 registered, 0 hidden and 8 guests (based on users active over the past 5 minutes)
Most users ever online was 1048 on Mon Feb 06, 2012 9:07 pm
Users browsing this forum: No registered users and 8 guests