V3 EndNote Question

[DavidWSnow]

I have two V3 PFD-style books in progress. One has all of the footnotes at the end and the other has them at the bottom of pages. I have the Compile => Foot & Endnote settings the same. I have an Endnote page just before the back matter with the magic endnote placeholder.

What is the V3 magic to get them all at the end?

[nontroppo]

Have you tried to change this here (and make sure you are turning footnotes into endnotes):

Screen Shot 2017-12-10 at 10.02.34_SML.png (18.17 KiB) Viewed 1091 times

I just tested on a test project and switching between End of Document and Before page breaks is working for a PDF compile here, though I didn't have a special <$--ENDNOTES--> document…

[DavidWSnow]

That was the first thing that I set, but I they still show up at the bottom of pages. After AL LOT more searching I found two more settings that are required on the Compile General settings

Screen Shot 2017-12-10 at 9.25.01 AM.png

Problem solved.

[xiamenese]

That was the first thing that I set, but I they still show up at the bottom of pages. After AL LOT more searching I found two more settings that are required on the Compile General settings
Screen Shot 2017-12-10 at 9.25.01 AM.png

Problem solved.

Except that your screenshot doesn't show, so …



Mark

[gr]

No doubt one of them is the other compile setting mentioned by nontroppo: "and make sure you are turning footnotes into endnotes" -- which is under the gear icon in the right panel of the main Compile dialog.

[nontroppo]

Yes, Endnote setting don't work unless footnotes are turned into endnotes...