Thu Feb 01, 2018 8:04 pm Post
Wed Feb 14, 2018 8:12 am Post
Mon Mar 05, 2018 5:54 pm Post
pcgeekesq wrote:800 points wide is useable but not as wide as I'd like.
Collider wrote:I can't get the changed width to show no matter what I do -- it's like it doesn't apply at all, even though the number remains saved.
Mon Mar 05, 2018 6:47 pm Post
thePhilosoraptor wrote:pcgeekesq wrote:800 points wide is useable but not as wide as I'd like.
If you'd like you can disable the fixed width editor, which should allow the editor to take up the entirety of the editor pane.
Wed Mar 07, 2018 12:04 pm Post
thePhilosoraptor wrote:What value are you attempting to change it to? And is Scrivener in full-screen mode or windowed?
Wed Mar 07, 2018 11:04 pm Post
Fri Mar 09, 2018 5:15 pm Post
The fixed width is only a maximum editor size, so it's possible if you are in windowed mode and only adjusting the size slightly you haven't yet made the maximum width small enough to be visible inside the already smaller area of the main editor. If you set it to something ridiculous, like 100, does that make any difference? Or does it still look the same? (Keep in mind the above issue of needing to refresh by loading another document).
In total there are 6 users online :: 0 registered, 0 hidden and 6 guests (based on users active over the past 5 minutes)
Most users ever online was 1048 on Mon Feb 06, 2012 9:07 pm
Users browsing this forum: No registered users and 6 guests