Page 1 of 1

I need help with the compile.

Posted: Thu Mar 08, 2018 10:53 pm
by krastev
Hi,

I need help with the compile.

Giving the binder structure on the screenshot, I want to achieve the following:

The chapter titles should be printed and there should be a Pg Break before each chapter.
The documents in Chapter One must be separated only with ###
The Folder 2-1 and Folder 2-2 titles should not be printed. Those two folders must be separated from each other by ###
The documents in the Folder 2-1 and Folder 2-2 should NOT be separated in any way.

Can I do this with the compile of Scrivener for Windows 1.9.7.0?

Thank you,
M

Re: I need help with the compile.

Posted: Fri Mar 09, 2018 2:32 am
by tomwood
krastev wrote:...
The documents in Chapter One must be separated only with ###
...
The documents in the Folder 2-1 and Folder 2-2 should NOT be separated in any way.


I don't think you can do this. The text document separators (Compile>Separators) are set globally and you're asking it to treat the same situation two different ways.

Re: I need help with the compile.

Posted: Sat Mar 10, 2018 8:26 pm
by krastev
Thank you, tomwood.

I found a way. Just, not by using the text document separators but instead the Section Layout... :)

Regards,
M